Why do we need to know Sheet metal Laser Cutting Machine?

Views: 0     Author: Site Editor     Publish Time: 2022-10-13      Origin: Site

Inquire

Why do we need to know Sheet metal Laser Cutting Machine?

The numerical control system controls the process parameters (cutting speed, laser power, air pressure, etc.) and motion trajectory of the laser cutting machine, and blows away the slag at the cutting joint through a certain auxiliary air pressure.

What is the fusion cutting of Laser metal Cutting Machine?

What should we pay attention to when using laser cutting machine?

What computer software should metal Laser Cutting Machine use?


What is the fusion cutting of Laser metal Cutting Machine?


In the melt cutting of Laser metal Cutting Machine, the workpiece is partially melted and the melt material is sprayed by air flow. Since the transfer of materials only occurs in the liquid state, this process is called laser cutting.

The laser beam is coupled with high-purity inert cutting gas to extrude the molten material out of the vent, while the gas itself does not cut. Laser cutting has higher cutting speed than gas cutting. The energy required for gasification is usually greater than that required to melt the material.


What should we pay attention to when using laser cutting machine?


1. The fire extinguisher should be kept at hand; Close the laser or shutter when not working; Do not place paper, fabric or other flammable materials near unprotected laser beams.

2. In case of any abnormality during processing, stop the laser cutting machine immediately and eliminate it in time or report to the supervisor.

3. Keep the laser, bed and surrounding site clean, tidy and free of oil stain, and stack parts, plates and wastes according to regulations.

4. When using gas cylinders, avoid crushing the welding wire to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the regulations on supervision and management of gas cylinders. Do not expose cylinders to direct sunlight or near heat sources. When opening the cylinder valve, the operator must stand on the cylinder port side.

5. Observe high voltage safety regulations during maintenance. Operate or maintain 40 hours a week, operate every 1000 hours or implement regulations and procedures every 6 months.

6. After starting the machine tool, manually start the machine tool in X and Y directions at low speed to check whether there is any abnormality.

7. After entering the new part program, it must be tested first and its working state must be checked.

8. When the laser cutting machine is working, pay attention to the working condition of the machine tool to avoid accidents caused by the deviation of the cutting machine from the effective travel range or the collision of two machines.


What computer software should metal Laser Cutting Machine use?


The operation of metal Laser Cutting Machine is divided into two parts: hardware and software. Materials are mainly concentrated. When focusing, all parts of the body shall not block the laser path and pay attention to burns. Software: there is special metal Laser Cutting Machine software, which can be used with consumer design software such as CAD and Photoshop.


Wuhan EETO Laser Equipment Co., Ltd. has been committed to providing customers with the best quality laser cutting machines for many years.

Content list
GET IN TOUCH WITH US
As our belief, small details make big differences! 
For more details of cooperation, please feel free to contact us.
 
Wuhan EETO Laser Equipment Co.,Ltd © 2021 - ALL RIGHTS RESERVED

Follow us